Digital Projector X21i/X26i Product Warranty and Safety Guide X21i/X26i Projecteur numérique - Garantie du produit et guide de sécurité X21i/X26i Digitalprojektor - Produktgarantie und Sicherheitshinweise X21i/X26i Proyector digital - Garantia de producto e Instrucciones de seguridad X21i/X26i Proiettore digitale - Garanzia del Prodotto e Manuale di Sicurezza X21i/X26i Digitale Projector - Garantie op het product en veiligheidsvoorschriften X21i/X26i Projector Digital - Garantia do Produto e Guia de Seguran
Product Warranty and Safety Guide Table of Contents 3M™ Digital Projector X21i/X26i ENGLISH 3M™ Digital Projector Limited Warranty . ...................................................................................................5 Safety Information .........................................................................................................................................7 Product Safety Labels ..............................................................................................
M™ Digital Projector X21i/X26iIn Product Warranty and Safety Guide Intentionally blank page © 3M 2012. All rights reserved.
3M™ Digital Projector X21i/X26i ENGLISH Product Warranty and Safety Guide Intentionally blank page 4 © 3M 2012. All rights reserved.
3M™ Digital Projector X21i/X26i Product Warranty and Safety Guide ENGLISH 3M™ Digital Projector Limited Warranty Warranty; Limited Remedy; Limited Liability The 3M Digital Projector (the “3M Product”) is warranted to be free from defects in material or manufacture for a period of three (3) years from the date of purchase or 2,500 hours of usage, whichever occurs first.
ENGLISH Product Warranty and Safety Guide 3M™ Digital Projector X21i/X26i FAILURE TO FOLLOW THE INSTRUCTIONS CONTAINED IN THE APPROPRIATE 3M PRODUCT MANUAL OR TO USE THE 3M PRODUCT IN ACCORDANCE WITH 3M’S INTENDED USE STATEMENT, WILL VOID ALL WARRANTIES AND LIMITED REMEDIES.
Safety Information Product Warranty and Safety Guide ENGLISH 3M™ Digital Projector X21i/X26i Read, understand, and follow all safety information contained in the “Product Warranty and Safety Guide” and in the “Operator’s Guide” prior to using the X21i/X26i Digital Projector. Service personnel must also read and understand the safety information contained in the “Service Manual”. Retain these instructions for future reference.
Product Warranty and Safety Guide 3M™ Digital Projector X21i/X26i ENGLISH WARNING • • • • • • • 8 To reduce the risk associated with choking: - Keep the battery away from children and pets. To reduce the risk associated with exposure to hazardous voltage: - Disconnect power cord when the projector is not in use, during lamp replacement, and while cleaning. - Do not remove any screws other than those specified in the lamp replacement instructions.
3M™ Digital Projector X21i/X26i Product Warranty and Safety Guide ENGLISH CAUTION • To reduce the risk associated with environmental contamination: - Dispose of exhausted batteries in accordance with applicable federal, state, and local regulations. • To reduce the risk associated with explosion, and/or chemicals from a leaking batteries: - Use only with battery type AA (HITACHI MAXELL or HITACHI MAXELL ENERGY, Part No.LR6 or R6P).
ENGLISH Product Warranty and Safety Guide Important Note 3M™ Digital Projector X21i/X26i 1. To avoid premature lamp failure, do not change the mounting position of the projector (desktop ceiling mount or ceiling desktop mount) and continue to use the same lamp. 2. To avoid reduced lamp life, do not touch projection lamp with bare fingers. 3. To avoid reduced image quality, do not touch projection lens or other internal optical components. 4.
© 3M 2012. All rights reserved.
ENGLISH Product Warranty and Safety Guide 3M™ Digital Projector X21i/X26i Connecting power supply 1. I nsert the connector of the power cord into the AC IN (AC inlet) of the projector. 2. Firmly plug the power cord into the outlet. In a couple of seconds after the power supply connection, the POWER indicator will light up in steady orange. Please remember that when the DIRECT POWER ON function is activated, the projector will turn on automatically when connected to power.
Lamp Product Warranty and Safety Guide ENGLISH 3M™ Digital Projector X21i/X26i Lamp Operation: The following symptoms may indicate a lamp in need of replacement: • LAMP indicator lights up red. WARNING • To reduce the risk associated with environmental contamination due to mercury in the projection lamp: - Dispose of lamp cartridge in accordance with applicable federal, state and local regulations. - The lamp in this product contains mercury.
ENGLISH Product Warranty and Safety Guide 3M™ Digital Projector X21i/X26i Replacing Lamp The glass lamp used in this projector contains small amounts of mercury and operates at high pressure and at high temperature and may unexpectedly shatter. Each lamp has a different lifetime and can fail in different ways, including a rupture with a loud bang or simply burn out. In the event of a lamp rupture, be sure to follow the instructions.
Product Warranty and Safety Guide √ Note For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass. Also, do not install an old or previously used lamp. 1. Remove lamp access door: Loosen the screw (marked by arrow) (1) of the lamp door and then slide and lift the lamp door (2) to the side to remove it. 2. Retaining screws : Loosen the 3 screws (marked by arrow) (3) of the lamp. Never loosen any other screws. √ Note All lamp module screws must be loosened.
ENGLISH Product Warranty and Safety Guide Remote control 3M™ Digital Projector X21i/X26i Installing the batteries Please insert the batteries into the remote control before using it. If the remote control starts to malfunction, try to replace the batteries. If you will not use the remote control for long period, remove the batteries from the remote control and store them in a safe place. 1 2 3 1. Holding the hook part of the battery cover, remove it. 2.
Product Warranty and Safety Guide ENGLISH 3M™ Digital Projector X21i/X26i FCC STATEMENT - CLASS B: This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual may cause interference to radio communications.
ENGLISH Product Warranty and Safety Guide Specifications Item 3M™ Digital Projector X21i/X26i Specification Product name Liquid crystal projector Liquid Crystal Panel 786,432 pixels (1024 horizontal x 768 vertical) Lamp 215 W UHP Speaker 1W Power supply/ Rated current AC 100-120 V: 3.3 A, AC 220-240 V: 1.6 A Power consumAC 100-120 V: 320 W, AC 220-240 V: 310 W ption Temperature 5 ~ 35 °C (Operating) range 306 (W) x 77 (H) x 221 (D) mm Size * Not including protruding parts.
Product Warranty and Safety Guide Troubleshooting - Warranty and after-service If an abnormal operation (such as smoke, strange odor or excessive sound) should occur, stop using the projector immediately. Otherwise if a problem occurs with the projector, first refer to “Troubleshooting” of Operator's Guide, Instant Stack Guide and Network Guide, and run through the suggested checks. If this does not resolve the problem, please consult your dealer or service company.
T-1 X21i/X26i a Screen size (diagonal) (1024 x 768) (±10%) 4 : 3 screen b c1 Projection distance Screen height min. max. type (inch) m m 30 40 50 60 70 80 90 100 120 150 200 250 300 0.8 1.0 1.3 1.5 1.8 2.0 2.3 2.5 3.0 3.8 5.1 6.4 7.6 0.9 1.2 1.5 1.8 2.1 2.4 2.7 3.0 3.6 4.6 6.1 7.6 9.2 inch m 34 1.0 46 1.4 58 1.7 70 2.1 82 2.5 95 2.8 107 3.2 119 3.5 143 4.3 179 5.3 240 7.1 300 8.9 361 10.7 c2 Screen height 16 : 9 screen b c1 Projection distance Screen height min. max.
F-3 Computer HDMI USB TYPE A DC5V 0.5A USB TYPE B COMPUTER IN1 COMPUTER IN2 AUDIO IN1 S-VIDEO VIDEO LAN AC IN AUDIO OUT MONITOR OUT AUDIO IN2 CONTROL F-4 Computer External device Access point USB wireless adapter (optional) USB storage device HDMI USB TYPE A DC5V 0.
F-5 HDMI USB TYPE A DC5V 0.5A USB TYPE B COMPUTER IN1 S-VIDEO VIDEO LAN AC IN AUDIO OUT MONITOR OUT HDMI S-VIDEO OUT L R AUDIO OUT VIDEO OUT L R AUDIO OUT COMPUTER IN2 AUDIO IN1 AUDIO IN2 CONTROL L R AUDIO OUT Y CB/PB CR/PR COMPONENT VIDEO OUT VCR/DVD/Blu-ray DiscTM player F-6 Speakers Monitor (with an amplifier) RGB IN HDMI USB TYPE A DC5V 0.
F-7 221 AC IN 77 83 306 [unit: mm]
3M Austin Center Building A147-5N-01 6801 River Place Blvd. Austin, TX 78726-9000 QR82371 3M Canada P.O. Box 5757 London, Ontario N6A 4T1 3M Mexico, S.A. de C.V. Apartado Postal 14-139 Mexico, D.F. 07000 Mexico 3M Europe Boulevard de l’Oise 95006 Cerge Pontoise Cedex France Please recycle. Printed in China © 3M 2012. All Rights Reserved. 78-6971-1603-2 Rev.
