User Guide

Installation Instructions
1. Strip wire insulation 1/2".
2. Firmly grasp wires, making sure
insulation ends are even and
tightly bundled. (Wires may be
twisted or untwisted.) Lead
stranded wires slightly. Slip the
connector over wire tips.
3. Turn connector onto wires in
clockwise direction until
secure.
4. To remove, turn connector
counter- clockwise.
WARNING
Turn power off before installing or
removing terminal. All electrical
work should be done according to
appropriate electrical codes.
3M is a trademark of 3M Company.
is a trademark of Underwriters
Laboratories.
is a trademark of Canadian
Standards Association.
is a trademark of the European
Union.
3
Electrical Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
800 245 3573
Fax [phone]
http://www.3M.com/electrical
Litho in USA.
© 3M 2003 80-6016-0084-6
Recycled paper
40% pre-consumer
10% post-consumer
Important Notice
Before using this product, you must
evaluate it and determine if it is suitable for
your intended application. You assume all
risks and liability associated with such use.
Warranty; Limited Remedy;
Limited Liability.
This product will be free from defects in
material and manufacture as of the date
of purchase. 3M MAKES NO OTHER
WARRANTIES INCLUDING, BUT NOT
LIMITED TO, ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. If this product
is defective within the warranty period
stated above, your exclusive remedy shall
be, at 3M’s option, to replace or repair the
3M product or refund the purchase price of
the 3M product. Except where prohibited
by law, 3M will not be liable for any loss
or damage arising from this 3M product,
whether direct, indirect, special,
incidental or consequential regardless
of the legal theory asserted.
O/B
+
T/R
+
R/Y
+
B/G
+
2#20 2#16 2#12 3#12 4#12 5#12 6#12 5#10
2#18 2#14 4#14 6#14 3#10 2#8 4#10
Combination
Combinaison
Combinacion
Wire Range Capabilities