User's Manual

Reader User Guide DT-018581

Figure 13: InstallShield Wizard Complete window

7. Click Finish.

Connecting to a Host System

The reader is supplied with a USB communication cable.

1. Insert the USB connector of the supplied cable into a USB port on the host system.

2. Insert the USB connector of the supplied cable into the USB host port, located on the

back panel of the reader.

Connecting the Power Supply

1. Connect the connector from the power supply to the power connector at the rear of the

reader.

Note: There is only one orientation that will allow the cable to be connected to the

power port.

2. Connect the AC cable to a functioning power outlet.

3. Turn on the power switch on the back panel of the reader.

Note: The power connector is a latching type that can not accidentally detach as the reader

is moved about. To remove the connector, grasp the connector shell and pull away

from the reader. The connector shell will slide backward slightly, allowing the

connector to disengage from the reader.

Verifying the USB Driver Installation

1. Right-click on My Computer and click on Properties.

The System Properties window opens.