User's Manual

3 -Installing a MiY Device  14
Proprietary
3.4.1 Connecting the Power Supply to the Terminal Blocks
To connect 12V power to the MiY-device:
1 Take the terminal block and connect the 12V wire to the last position and the ground wire
to the next position.
Terminal Positions (Red: 12V, Black: Ground)
2 Take a small flat-head driver and tighten the screws to hold the wires in-place
Tightening Screws
3 Connect the terminal block to the terminal block connector A. When power is available, the
MiY-Device will turn on.
3.4.2 Connecting the Power Supply by Ethernet Port (Power over Ethernet)
Category 5 (CAT-5) Ethernet cables that have Power over Ethernet (PoE) can be connected to the
Ethernet port of the MiY device as a supply of power. If the MiY device can not be powered by
Power over Ethernet (PoE), troubleshoot using the procedure detailed in this subsection.
To troubleshoot the MiY’s PoE:
1 Connect a CAT-5 Ethernet cable between the Ethernet port of the MiY device and an 802.3af
PoE-enabled hub