User's Manual

⎟ 45
8
If the list test shows the results you want, click
Save Changes. The validators are added to the
ID Settings page.
To return to the ID Settings page, click ID
Settings in the navigation bar.
To test a single validator
1 On the Add Validator or Edit Validator page, in
the Test ID box, type an ID in the format you
want to pass.
2 Click Test the Barcode. The pass or fail result
appears in the Result box.
3 To test the validator against other ID formats,
repeat the preceding steps.
Add Validator page
To test a list of validators
1 On the Item Validators page, in the Test ID box,
type an ID in the format you want to test.
2 Click Test the Chain. The pass or fail result
appears in the Result box.
3 Repeat for each ID format that you want to
accept or reject.
This test compares the test ID to each validator in
the list in the order listed and applies the first vali-
dator that matches. If the result is unexpected,
usually it is because the constraints are not
exclusive enough. In the example to the right, the
only 10-character IDs that pass have the
characters CD starting at position 3. All other 10-
character IDs are excluded.
Testing a list of validators
To edit a validator
1 On the Item Validators page, click the edit icon
( )
for the validator
you want to edit. The Edit Item Validator page opens with the validator
commands loaded.
2 Edit the validator commands, and then test and save the validator twice
—first on the Edit Item Validator page and then on the Item Validators
page.
To remove a validator
1 On the Item Validators page, click the delete icon
( )
for the validator
you want to remove. The validator is removed from the list.
2 Test the list of validators again, and then click Save Changes.