User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
⎟ 9
7
To determine which COM port has been assigned to
this printer, click Start, click Run, type usbman, and
then click OK. Note the COM port number, and then
close the Ithaca USB Manager.
8 Click Start, and then click Run.
9 In the Open box, type d:\printer\setup comx,
where d is the drive letter of the CD drive and x is
the COM port assigned to the printer, and then
press ENTER. For example, if the CD drive is drive
E and the printer is assigned to COM3, type
e:\printer\setup com3.
10 When you see a dialog box with the message
"Exiting Printer Configuration," click OK.
11 Cycle the printer power by unplugging the printer
power cord, and then plugging it back in. (Do not
use the power switch—it is disabled.)
12 Click Start, and then click Start 3M
SelfCheckCSeries.
13 Open SelfCheck System Manager, and then enable
the printer on the Devices tab.
14 Remove the CD from the CD drive, place it back into
its case, and then put it in a safe place.
7 Note the COM port the printer is assigned to
9 Run the printer configuration utility