User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
6 ⎟
Several command windows appear while
the update process is running.
When the update is finished, a completion
message appears.
7 Remove the CD from the CD drive and
place it back into its case.
8 Click Yes to restart the computer.
9 Go to “Step 2 – Install the 3M™
SelfCheck™ System software.”
Command window
Completion message
Step 2 – Install the 3M™ SelfCheck™ System software
1 Start the computer if it is not running.
2 Insert the SelfCheck System C-Series CD. It should start automatically.
3 Follow the instructions that appear on the screen until you are notified in
the command window that the installation is complete.
4 Go to “Step 3 – Install the printer drivers.”
Step 3 – Install the printer drivers
Before you can use the Ithaca
®
iTherm™ Series 280 printer that is supplied
with the SelfCheck system, you must install and configure the Ithaca USB
port and printer drivers.
Install the USB port and driver
1 Make sure the printer’s USB cable is not connected
to the computer.
2 Plug the Ithaca iTherm Series 280 printer into a
power source, and then turn on the printer.
3 Connect the USB cable between the printer and
your computer.
4 When the Found New Hardware Wizard appears,
click Install from a list or specific location, and
then click Next.