User's Manual

 13
General maintenance
Replacing the printer paper
When the printer paper runs out, use the following procedure to replace it
with a new roll of paper:
To order printer paper rolls, see "Obtaining service and supplies" on
page 14.
1 Press the cover open button, and lift the printer cover.
2 Place the paper roll in the printer so the paper unwinds from the bottom.
3 Pull the front edge of the paper out until it is past the front edge of the
printer.
4 Close the printer cover.
Cleaning the components
The 3M™ SelfCheck™ System components can become dirty with normal
use and may require cleaning. To clean the component exteriors, dampen a
soft cloth with water or a mild cleaning solution and gently wipe away dirt
from the affected areas.
Cleaning the monitor
§ Shut down the SelfCheck system.
§ Use care when cleaning the SelfCheck system monitor.
§ Use pre-moistened towelettes that are sold specifically for monitor
cleaning. If these are not available, you can use a non-solvent based
cleaner to dampen a soft cloth, but use it very sparingly.