Datasheet
3M SprayMount Adhesive.
__________________________________________________________________________________________
Page: 6 of 20
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Ventilate
the area with fresh air. Refer to other sections of this SDS for information regarding physical and health hazards, respiratory
protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
If possible, seal leaking container. Place leaking containers in a well-ventilated area, preferably an operating exhaust hood, or
if necessary outdoors on an impermeable surface until appropriate packaging for the leaking container or its contents is
available. Cover spill area with a fire-extinguishing foam. An appropriate aqueous film forming foam (AFFF) is
recommended. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent
material does not remove a physical, health, or environmental hazard. Collect as much of the spilled material as possible
using non-sparking tools. Place in a metal container approved for transportation by appropriate authorities. Collect the
resulting residue containing solution. Clean up residue with an appropriate solvent selected by a qualified and authorised
person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label and Safety Data Sheet. Seal
the container. Dispose of collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not use in a confined area with minimal air exchange. Keep out of reach of children. Do not handle until all safety
precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not
spray on an open flame or other ignition source. Do not pierce or burn, even after use. Do not breathe
dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this
product. Wash thoroughly after handling. Avoid release to the environment. Avoid contact with oxidising agents (eg.
chlorine, chromic acid etc.) Use personal protective equipment (eg. gloves, respirators…) as required. Vapours may travel
long distances along the ground or floor to an ignition source and flash back.
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Protect from sunlight. Do not expose to temperatures exceeding 50C/122F. Store away
from heat. Store away from acids. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Butane 106-97-8 Health and
Safety Comm.
(UK)
TWA:1450 mg/m³(600
ppm);STEL:1810 mg/m³(750
ppm)