Operation Manual

Usage Notice 3M™ Super Close Projection System

WARNING

• Lamp replacement caution. Before removing the screws, discon-

nect the power cable. Hot surface inside. Allow 1 hour to cool

before replacing the lamp. Handle with care. Risk of explosion.

See Owner's Manual.

• Unplug the projector from the electrical outlet and allow the lamp

to cool for 60 minutes before replacing the lamp.

• Wait at least 30 minutes for the lamp assembly to cool before

replacing.

• Always handle the fragile lamp module with care.

• In the event of a lamp rupture, call a 3M authorized service pro-

vider for repair. Ruptured lamp is not user serviceable.

• Ventilate the area where the lamp rupture occurred. The lamp

operates at high pressure and temperature.

• Replace the lamp module when the lamp replacement message

appears.

• Never replace the lamp module with a previously used lamp

module.

• Hg: Lamp contains mercury. Don't throw in trash. Dispose ac-

cording to local, state, or federal laws. See www.lamprecycle.org

or call 1-800-328-1371.

• Wash your hands thoroughly if contact with ruptured lamp debris

has taken place.

• Ventilate the area where the lamp rupture occurs. The lamp oper-

ates at high temperature.