Operation Manual

3M™ Super Close Projection System Usage Notice

WARNING

• Do not attempt to service the projector other than performing

routine lamp replacement. Service should only be performed by

a 3M authorized service provider. Aside from the projection lamp

assembly, there are no serviceable parts inside the unit.

• Contact a 3M authorized service provider for service.

• Do not modify this projector.

• Do not allow water or other liquids to enter the projector.

• Do not operate this projector in wet environments or outdoors.

• Do not use this projector around unsupervised children.

• Replace power cord if damaged.

• Contact a 3M authorized service provider if the projector be-

comes damaged.

• Connect this projector into a grounded outlet.

• Use a grounded extension cord with a rating at least equal to that

of the projector.

• Use only the 3M brand wall mounting hardware kit if wall mount-

ing is desired.

- Installation of 3M wall kit must only be performed by qualied

personnel.

- Adhere strictly to the proper installation procedure as outlined in

the installation instructions when installing the 3M wall kit.

• Always operate the unit on a at, sturdy, and horizontal surface.

• Before operating, please read owner's manual. Do not remove

screws except lamp cover screws. Do not block venting open-

ings.