User's Instructions

7
Docking Station
WARNING
Do not disassemble, modify or service this device. The Docking Station contains no user serviceable
parts except for the wall mount hardware. System components requiring any necessary repairs or
service would need to be sent into an authorized 3M service center.
The 3M™ Connected Safety Hub Docking Station provides a power source for Safety Hubs to charge
and an Ethernet port to upload data that may not have already been sent to the Connected Safety cloud
application via Wi-Fi. It is recommended to be placed and used in clean environments that are a cool,
well-ventilated location free of particulates, combustible material, other airborne contaminants, and
outside of classified intrinsically safe areas.
1. Insert DC power supply cord from the 3M™ Power Supply TR-941N into the dock (Figure 2).
Plug the power cord into an AC power source (100-240V), such as a wall outlet.
2. Insert Ethernet patch cable into the RJ-45 network port (Figure 2.1). Do not connect to an
Ethernet network that goes directly outside of the building.
Docking Stations can be placed for use on flat surfaces, or wall mounted with the included hardware. If
using the wall mount option, the included lugs and screws will need to be attached to the bottom of the
dock. Securing the wall mount plate to a vertical surface will require additional hardware that is not
included with the kit. The type of screws and / or anchors needed will depend on the surface material
intended to be mounted on. The wall mount plate holes can use screws up to 4.74mm in diameter.
Operating temperature range:
5°C (41°F) to 50°C (122°F)
Storage temperature range:
-20°C (-4°F) to 60°C (140°F)
Figure 2
Figure 2.1