Specifications

3M™ MicroTouch™ Display M1700SS User Guide 21
Document #19-268 Rev AL
3. Connect one end of the touch sensor cable (either serial or USB) to the display.
Connect the other end to an available port on the back of your computer. If you are
using a USB connection, make sure you have installed the Touch Software drivers
before connecting the touch sensor cable.
4. Plug the AC/DC power supply into the M1700SS Display. Be sure to use the power
supply included with the display.
WARNING
To avoid the risk of electric shock which could result in serious injury or death:
• This device must be operated with the original power supply, part numbers
• HJC - HASU05F
• AC Adapter – STD1204
• Li Shin – 0217B1250
CAUTION
To avoid the risk of electric shock which may result in minor or moderate injury:
• The socket-outlet should be installed near the equipment and should be easily
accessible.
• Use a power cable that is properly grounded. Always use the appropriate AC cord
certified for the individual country. Some examples are listed below:
USA UL
Switzerland SEV
Canada CSA
Britain BASE/BS
Germany VDE
Japan Electric Appliance Control Act
5. Connect the power cable to the AC/DC supply. Connect the other end to the
appropriate AC outlet.