User's Manual

SelfCheck™ Manager Procedures

This section contains common procedures for configuring and

adjusting the SelfCheck Manager.

Mode Procedures

Use the following procedures to set the SelfCheck™ System in

different modes of operation:

SelfCheck System Mode

Select SelfCheck from the Modes menu. This sets the SelfCheck

system for normal patron operation.

Out of Service Mode

Select Out of Service from the Modes menu. This sets the

SelfCheck system in the out of service mode and shows the out of

service graphic on the screen. When the Out of Service graphic is

displayed, pressing the escape key (Esc) on the returns you to the

SelfCheck™ Manager.

Demonstration Mode

Select Demonstration from the Modes menu. Putting the

SelfCheck system in the demonstration mode allows check out of

items for training or demonstration purposes. While in the

demonstration mode the SelfCheck system does not communicate

with any other system.

Circulation Procedures

SelfCheck System Use: Check-in, Check Out, or Patron Selectable

The SelfCheck system is used to check-in or checkout library items.

The SelfCheck system may be set to allow the patron to choose

check-in or checkout, or it may be set for check-in or checkout only.

1 Click Policy from the Configure menu.

2 Click the Circulation tab on the Policy

Properties window.

3 Click the button next to the desired

mode.

4 Click OK.

Policy Properties window - Circulation tab