SDS

3M™ Wall Repair Fiber Reinforced Compound 02/01/16
__________________________________________________________________________________________
Page 5 of 10
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Safety Glasses with side shields
Skin/hand protection
No chemical protective gloves are required.
Respiratory protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for particulates
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
General Physical Form:
Liquid
Odor, Color, Grade:
white paste with very slight ammonia odor.
Odor threshold
No Data Available
pH
9
Melting point
Not Applicable
Boiling Point
212 ºF
Flash Point
>=201 ºF [Test Method: Closed Cup]
Evaporation rate
No Data Available
Flammability (solid, gas)
Not Applicable
Flammable Limits(LEL)
No Data Available
Flammable Limits(UEL)
No Data Available
Vapor Pressure
18 mmHg [@ 20 ºC]
Vapor Density
>=1 [Ref Std: AIR=1]
Density
.54 g/cm3
Specific Gravity
.3 - .8
Solubility In Water
30 %
Solubility- non-water
No Data Available
Partition coefficient: n-octanol/ water
No Data Available
Autoignition temperature
No Data Available
Decomposition temperature
No Data Available
Viscosity
>=4,000 centipoise
SECTION 10: Stability and reactivity
10.1. Reactivity
This material is considered to be non reactive under normal use conditions.
10.2. Chemical stability
Stable.
10.3. Possibility of hazardous reactions
Hazardous polymerization will not occur.