Datasheet

3M
™
Scotch-Weld
™
Low-Odour Acrylic Adhesives
DP810 • DP810 Black • DP810 NS
- 5 -
Handling/Curing
Information
Directions for use:
Apply adhesive to clean, dry substrates, which are free of paint, oxide films, oils, dust,
mold release agents and all other surface contaminants. See the Surface Preparation
section for specific substrate preparation method.
50 ml cartridge:.
Place Duo-Pak cartridge in 3M™ EPX Applicator. Remove cap. Dispense and discard
a small amount of adhesive to assure even ratio and free flow. Clear orifice if necessary.
Attach mixing nozzle. Apply adhesive to clean surfaces, join parts, secure until
adhesive sets.
200/400 ml cartridge
While holding Duo-Pak cartridge in an upright position, remove and discard the insert
from the cartridge by unscrewing plastic nut and removing metal washer. Place
cartridge in a 1:1 200/400 ml EPX applicator. Dispense and discard a small amount of
adhesive to ensure even ratio and free flow. Attach mixing and nozzle and secure with
plastic retaining nut. Apply adhesive to clean surfaces, join parts, secure until
adhesive sets.
Clean-up:
Excess adhesive can be removed with solvent such as MEK * .
part or bond line can be removed with isopropyl alcohol.*
Edge tack on a finished
*Note: When using solvents, extinguish all ignition sources and follow the
manufacturer’s precautions and directions for use.
Heat Cure:
Full cure can be attained by raising the bondline temperature to 49°C (120°F) for
30 minutes or to 66°C (150°F) for 10 minutes.