Datasheet

3M™ Scotch-Weld™ Epoxy Potting Compound/Adhesive DP270 Clear, Part B
__________________________________________________________________________________________
Page: 6 of 15
POLYMER (MW unknown
or <=700)
4,4'-
ISOPROPYLIDENEDIPH
ENOL-
EPICHLOROHYDRIN
POLYMER (MW unknown
or <=700)
Freshwater sediments
0.5 mg/kg d.w.
4,4'-
ISOPROPYLIDENEDIPH
ENOL-
EPICHLOROHYDRIN
POLYMER (MW unknown
or <=700)
Intermittent releases to water
0.013 mg/l
4,4'-
ISOPROPYLIDENEDIPH
ENOL-
EPICHLOROHYDRIN
POLYMER (MW unknown
or <=700)
Marine water
0.0003 mg/l
4,4'-
ISOPROPYLIDENEDIPH
ENOL-
EPICHLOROHYDRIN
POLYMER (MW unknown
or <=700)
Marine water sediments
0.5 mg/kg d.w.
4,4'-
ISOPROPYLIDENEDIPH
ENOL-
EPICHLOROHYDRIN
POLYMER (MW unknown
or <=700)
Sewage Treatment Plant
10 mg/l
8.2. Exposure controls
In addition, refer to the annex for more information.
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Indirect vented goggles.
Applicable Norms/Standards
Use eye protection conforming to EN 166
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the