Datasheet

3M™ Scotch-Weld™ Epoxy Potting Compound/Adhesive DP270 Clear, Part A
__________________________________________________________________________________________
Page: 6 of 13
Applicable Norms/Standards
Use gloves tested to EN 374
Respiratory protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part
of a full respiratory protection program. Based on the results of the exposure assessment, select from the following
respirator type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours
For questions about suitability for a specific application, consult with your respirator manufacturer.
Applicable Norms/Standards
Use a respirator conforming to EN 140 or EN 136: filter type A
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state
Liquid.
Appearance/Odour
clear, very mild pungent odour.
Odour threshold
No data available.
pH
Not applicable.
Boiling point/boiling range
205 ºC [Details:CONDITIONS: @ 760mm Hg (benzyl alcohol)]
Melting point
No data available.
Flammability (solid, gas)
Not applicable.
Explosive properties
Not classified
Oxidising properties
Not classified
Flash point
> 115.6 ºC [Test Method:Closed Cup]
Autoignition temperature
No data available.
Flammable Limits(LEL)
No data available.
Flammable Limits(UEL)
No data available.
Vapour pressure
13.3 Pa [Details:CONDITIONS: @ 86F (30C); 13.3mm Hg @
212F (100C).]
Relative density
1 [Ref Std:WATER=1]
Water solubility
Slight (less than 10%)
Solubility- non-water
No data available.
Partition coefficient: n-octanol/water
No data available.
Evaporation rate
No data available.
Vapour density
3.72 [Ref Std:AIR=1]
Decomposition temperature
No data available.
Viscosity
12,000 - 15,000 mPa-s [Details:CONDITIONS: (@ Room
Temperature)]
Density
1 g/ml
9.2. Other information
EU Volatile Organic Compounds
No data available.
Molecular weight
No data available.
SECTION 10: Stability and reactivity
10.1 Reactivity
This material may be reactive with certain agents under certain conditions - see the remaining headings in this section
10.2 Chemical stability
Stable.