Cut Sheet

3M™ Direct Bury Splice Kit DBR/Y-6
2 of 3
Installation
Instructions
1) ¾ in. 2)
3) 4) 5)
1) Strip insulation ¾ in.
2) With wire ends even, insert wires into the connector and tighten until secure.
3) Insert the connector all the way into the tube until the connector rests on the bottom.
4) Fold the wire into the channels.
5) Close the cap.
Installation Tip:
If having difficulty getting the twist-on connector down into the tube when using small
gauge wires, use a thin non-conductive object to push the connector to the bottom of the
tube. Upon removal of the object, ensure that no voids or water paths remain in the
grease.
Warning
Turn power off before installing or removing connector. All electrical work should be done according to
appropriate electrical codes.