User Guide

Application Tips
Applicator is assembled by inserting the plunger at the rear of the 3M
™
EPX
™
Applicator. A duo-pak adhesive cartridge is
inserted in a slot on the front of the applicator. The mixing nozzle is trimmed for the desired bead size and inserted into the
front of the cartridge with a twisting motion. A bead of the desired thickness is applied to the part by squeezing the handle.
3M
™
Scotch-Weld
™
Epoxy Adhesive is advanced through the mixing tube and applied to the motor shaft or housing. The
bearingis pressed to the shaft or the two pieces of the housing are pressed together and secured while the adhesive cures to a
permanent bond.
For More Information
• See 3M
™
Epoxy and Hot Melt Adhesives for Electronics brochure (78-6900-9828-6)
Related Application Ideas
Pivot cartridge bearing bonding.
Industrial Business
3M Center, Building 220-8E-04
St. Paul, MN 55144-1000
Printed in USA
Hddmb460.pdf
© 3M 2002
For Additional Information
To request additional product information or to arrange for sales assistance, call 1-800-362-3550. Address
correspondence to: 3M Industrial Business Customer Response Center, 3M Center, Building 220-8E-04,
St. Paul, MN 55144-1000. Our fax number is 651-733-9175. In Canada, phone: [phone]. In
Puerto Rico, phone: [phone]. In Mexico, phone: [phone].
Important Notice
3M MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO,
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. All statements, technical information and recommendations contained in this document are
based upon tests we believe to be reliable. However, many factors beyond the control of 3M can affect the
use and performance of 3M products in a particular application, including the conditions under which the
product is used and the time and environmental conditions in which the product is expected to perform.
Since these factors are uniquely within the user’s knowledge and control, it is essential that the user
evaluate the 3M product to determine whether this product is fit for a particular purpose and suitable for
the user’s application.
Limitation of Remedies
and Liability
If the 3M product is proved to be defective, THE EXCLUSIVE REMEDY, AT 3M’S OPTION, SHALL
BE TO REFUND THE PURCHASE PRICE OF OR TO REPAIR OR REPLACE THE DEFECTIVE 3M
PRODUCT. 3M shall not otherwise be liable for any loss or damages, whether direct, indirect, special,
incidental, or consequential, regardless of the legal theory asserted, including, but not limited to, contract,
negligence, warranty, or strict liability.
Ashesive
3M™ EPX™ Applicator
3M, Scotch-Weld and EPX are trademarks of 3M.