Product Manual

Configuration
3M™ Wireless Communication System Model XT-1
Installation Manual
September 2012 – Revision 1.9 DRAFT
Page 47 of 68
Load Installation Settings
Installation settings are a complete set of configuration data that the installer can
save after the initial installation configuration is completed. It is essentially a
backup save point in case configuration settings are inadvertently changed in
ways that are not easy to identify or correct.
To load the installation settings:
Important Note:
By performing this procedure you will be erasing the current configuration
and reloading the configuration that was last saved, likely when the system
was first installed.
• Enter the configuration mode, see page 31.
• Select 14 Installer Setup .
• Change the value for Load Installation Settings to Yes .
Save Installation Settings
Note:
This function is only available to installers.
Perform the following procedure to save the current configuration into
permanent memory over the existing installation settings.
Important Note:
By performing this procedure you will be erasing the existing saved
installation settings, making it impossible to revert to the settings that were
saved after installation.
• Enter the configuration mode, see page 31.
• Select 14 Installer Setup .
• Change the value for Save Installation Settings to Yes .
Technical Service Message
Perform the following procedure to customize the Service Screen message.
• Enter the configuration mode, see page 31.
• Select 14 Installer Setup .
• Change the value for Use Custom Tech Service Message? to Yes
or No .
• If you chose Yes , enter the customer message.
Reset Timer Database
Perform the following procedure to Reset the Timer module database.
• Enter the configuration mode, see page 31.
• Select 14 Installer Setup .
• Change the value for RESET Timer Database to Yes .
Note:
Resetting the Timer module Database will clear ALL vehicle timing data.