Product Manual

Configuration
September 2012 – Revision 1.9 DRAFT
Page 46 of 68
3M™ Wireless Communication System Model XT-1
Installation Manual
• To enable or disable self monitoring, change the value for Self
Monitoring Enabled? to Yes or No .
• If self monitoring is enabled:
• Select a value for Number of Inactive Days Allowed .
The range is 7 to 255. The number represents how many days of
inactivity must pass for any given headset before the system
interprets the absence as a problem and forwards the information
to 3M.
• Select a value for Resend Error Reports . Your choices are
Never , Every Day , Every Week , or Every Month . This is
the frequency that the base station will attempt to resend the
error message until the error condition is corrected.
Change Passcodes
User and installer passcodes can be individualized for better security control
against unauthorized changes. The system has a default user and a default
installer passcode pre-installed. Check your documentation for those passcodes.
User Passcodes
If you enter a user passcode, you have full access to the Change User Passcodes
menu. You can change or delete any passcode.
Perform the following procedure to set up and/or change user passcodes:
• Enter the configuration mode, see page 31.
• Select 13 Change Passcodes > Change User Passcodes .
• Identify the user number you want to change, then press , , ⊳, and
 as necessary to scroll to the desired passcode.
• Enter a new four-digit passcode in place of the old passcode.
• Press Enter to implement the change or press Mode to abandon the
change and leave the passcode at its previous setting.
Two Base Station Setup
In any installation where there are two base stations (tandem, side-by-side, or
dual drive thrus), register all headsets to Base Station #1. This ensures that
changes to split and cross lane mode and the order taking mode are
synchronized between the two base stations. The difference between split lane
and cross lane modes in this situation is:
• Split lane mode is intended for a drive thru with two order takers. Each
order taker hears beeps only for the lane for which the headset is
configured: beeps from the other lane will not be heard.
• Cross lane mode is intended for a drive thru with one order taker who
will hear beeps for both lanes on one headset. You can configure the
system to permit non-order takers to hear orders and pages from one or
both sides. See “Order Takers and Page Messages in Cross Lane
Mode,” page 42.
Installer Setup
Installer setup is a special group of setup options typically only used by the
installer or in case of complete system restoration or backup.