Product Manual

Configuration
September 2012 – Revision 1.9 DRAFT
Page 44 of 68
3M™ Wireless Communication System Model XT-1
Installation Manual
In the event the Kitchen Noise Reduction feature has been disabled due to a
headset with an older version of software having signed on, use the base
station’s menu to identify and remove the offending headset(s) before restarting
the base station, in order to restore the feature.
1. Identify the serial number(s) of the headset or headsets that have a software
version other than v5.11
• Enter the base station configuration mode, see page 31.
• Navigate to 08 Headset Setup > Currently Editing Headset .
• Press ⊳ or  if necessary to scroll through the headsets. The
software version appears below the headset ID number.
2. Unregister the headset(s) identified above by performing the following
steps
• Enter the base station configuration mode, see page 31.
• Select 04 Registration > 2 Remove Headsets .
• Scroll to the number of the headset you want to un-register.
• Press Enter.
3. Rebooting the base station will now restore the Kitchen Noise
Reduction feature.
Order Taking Modes Setup
Perform the following procedure to enable or disable some of the seven different
order taking modes from appearing on the Run Menu:
• Enter the base station configuration mode, see page 31.
• Navigate to 09 O.T. Modes Setup .
• Change the value for each of the following options to Yes or No :
• Manual Listen/Push To Talk
• Manual Listen/Manual Latching Talk
• Auto Listen/Push To Talk
• Auto Listen/Manual Latching Talk
• Hands Free
• Outside
• Always On (Bypass Vehicle Detector)
(Press  or  to scroll up and down the list)
Notes:
Order taking modes are described in the Operation section.
3M recommends you do not set up more than three order taking modes.
Change Site Scheduling
The site schedule is the calendar of store open and closing times.
Note:
All timekeeping is done using a 24 hour clock (e.g., 6:00 p.m. appears as
18:00).