Product Manual
Configuration
3M™ Wireless Communication System Model XT-1
Installation Manual
September 2012 – Revision 1.9 DRAFT
Page 35 of 68
Outbound Talk Volume
Changing the outbound talk volume affects the volume of the speaker at the
customer order point.
Note:
To avoid feedback, set the outbound talk volume as low as possible.
To change the outbound talk volume:
• Enter the configuration mode, see page 31.
• Select a new value for
01 Drivethru Volume
>
Outbound Talk
Volume
. The range is 0 (silent) to 20 (maximum).
Vehicle Alert Volume
Changing the vehicle alert volume affects the volume of the vehicle alert signal
on the headsets.
To change the vehicle alert volume:
• Enter the configuration mode, see page 31.
• Select a new value for
01 Drivethru Volume
>
Vehicle Alert
Volume
. The range is 0 (silent) to 20 (maximum).
Outbound Greeter Message Volume
Changing the outbound greeter message volume affects the sound volume of the
custom greeting messages and the system internal greetings (“Store Closed” and
“Pull Forward”).
To turn up or down the greeter message volume:
• Enter the configuration mode, see page 31.
• Select a new value for
01 Drivethru Volume
>
Greeter Message
Volume
. The range is 0 (silent) to 20 (maximum).
Change the Monitor Volume
The monitor is an additional speaker that can be used to monitor drive thru
communication without a headset, typically in the kitchen. If the monitor has a
volume control built into it, you can use it to control the overall volume level of
the speaker. To be more specific about which elements you want to control,
follow the instructions in the following sections.
Inbound Listen
Changing the inbound listen volume affects how loudly the monitor plays the
inbound (customer order point) communication. You can also disable the
monitor playing inbound sounds.
To change the inbound listen monitoring settings:
• Enter the configuration mode, see page 31.
• Select
02 Monitor Volume
.
• To enable or disable the monitor playing the inbound sounds, change
the value for
Inbound Listen: Enable
to
ON
or
OFF
.
• To change the volume level, select a new value for
Inbound Listen:
Volume
. The range is 0 (silent) to 20 (maximum).