Product Manual

Installation
3M™ Wireless Communication System Model XT-1
Installation Manual
September 2012 – Revision 1.9 DRAFT
Page 17 of 68
Connect the Components
This section provides diagrams and information that should help you to properly
wire the system components together.
Note:
In all cases, you must have one base system for each order point (i.e., you
cannot run two or more order points from a single base station).
Base Station Wiring Terminal Identification
Figure 7 identifies all of the wiring terminals and their labels. The table that
follows provides definitions of the labels and identifies where they should be
connected in the system.
Figure 7