Product Manual

Installation
September 2012 – Revision 1.9 DRAFT
Page 16 of 68
3M™ Wireless Communication System Model XT-1
Installation Manual
Figure 6
2. Attach the base station to the wall using screws and possibly wall
anchors.
Note:
Steps 3 and 7 assume that all of the communication cabling has been prepared
and is available at the base station. If not, see “Base Station to Component
Wiring,” page 19.
3. Follow local best practices and any applicable regulations to route the
cables into the base station cabinet’s top, sides, or back (through the
wall) as neatly as possible. Do not route power supply wiring with
communication wiring in the same conduit.
4. Attach all cables to their appropriate terminals.
5. Connect the base station transformer between the wall outlet and the
base station power supply connection.