User's Manual

Configuration
3M™ Wireless Communication System Model XT-1
Installation Manual
September 2012 – Revision 1.9 DRAFT
Page 35 of 66
Outbound Talk
C
hanging the outbound talk volume affects how loudly the monitor plays the
outbound (order taker) communication. You can also disable the monitor
playing outbound talk.
Note:
To avoid feedback and echo, set the outbound talk volume as low as possible.
To change the outbound talk monitoring settings:
• Enter the configuration mode, see page 30.
• Select 02 Monitor Volume.
• To enable or disable the monitor playing the outbound talk, change the
value for Outbound Talk: Enable to ON or OFF.
• To change the volume level, select a new value for Outbound Talk:
Volume. The range is 0 (silent) to 20 (maximum).
Vehicle Present
Changing the vehicle present volume affects how loudly the monitor plays the
vehicle present tone. You can also disable the monitor playing the vehicle
present tone.
To change the vehicle present monitoring settings:
• Enter the configuration mode, see page 30.
• Select 02 Monitor Volume.
• To enable or disable the monitor playing the vehicle present tone,
change the value for Vehicle Present: Enable to ON or OFF.
• To change the volume level, select a new value for Vehicle
Present: Volume. The range is 0 (silent) to 20 (maximum).
Vehicle Approach
Some sites are equipped with a vehicle approach detector, which alerts you
when a vehicle enters the parking lot or drive through approach lane. If your
site is equipped with the detector, you can change the volume at which the tone
is played on the monitor. Also, if you do not wish to hear the tone, you can
disable it.
To change the vehicle approach monitoring settings:
• Enter the configuration mode, see page 30.
• Select 02 Monitor Volume.
• To enable or disable the monitor from playing the vehicle approach
tone, change the value for Vehicle Approach: Enable to ON or
OFF.
• To change the volume level, select a new value for Vehicle
Approach: Volume. The range is 0 (silent) to 20 (maximum).
Page Messages
Paging is headset-to-headset communications. Changing the page message
volume affects how loudly the monitor plays internal paging messages. You can
also disable the monitor playing internal paging messages.
Note:
To avoid feedback and echo, set the volume as low as possible.