Installation Manual

Configuration
April 24 2015 – Revision 1.0
Page 54 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
• If you chose Yes , enter the customer message.
Number of Base Stations at this Site – Move this to Installer Setup
The G5 Basestation Model G5B1 can function as a Single or Dual Lane system
Perform the following procedure to enable the basestation to operate as a dual
lane or single lane system:
• Enter the base station configuration mode, see page 34.
• Change the value for 14 Installer Setup > Number of Lanes
At This Site to 2 .
(or to 1 if this is a dual lane system but being installed to function on a
single lane)
• Press Enter to implement the change.
Important Note:
The Dual Lane functionality on the G5 Basestation Model G5B1 is not active,
by default, when purchasing a new system. Dual Lane functionality on the G5
Basestation Model G5B1 must be activated by calling this number
1-800-328-0033
Factory Setup (Restore Factory Defaults)
Perform the following procedure to restore all of the configuration settings to the
factory default settings. This procedure should be performed only if the current
configuration and the saved installation settings are unusable.
Important Note:
By performing this procedure you will reset the system to the initial
configuration, making it impossible to revert to the settings that were saved
after installation.
• Enter the configuration mode, see page 34.
• Select 15 Factory Setup .
• Change the value of Restore All Factory Settings to Yes .
Create and Load Templates
You can save an entire base station configuration as a file on a PC and use the
file as a template for other base stations. You must be using a PC to use
templates.
Reboot System
Perform the following procedure to cleanly power down, then power up without
unplugging the system:
• Enter the configuration mode, see page 34.
• Select 17 Reboot System .
• Change the value of Power Cycle Complete System to Yes .
• Press Service.
Check the Revision Levels
Perform the following procedure to view the revision levels and serial numbers
of your base station:
• Enter the configuration mode, see page 34.