Installation Manual

Configuration
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 53 of 76
• Split lane mode is intended for a drive thru with two order takers. Each
order taker hears beeps only for the lane for which the headset is
configured: beeps from the other lane will not be heard.
• Cross lane mode is intended for a drive thru with one order taker who
will hear beeps for both lanes on one headset. You can configure the
system to permit non-order takers to hear orders and pages from one or
both sides. See “Order Takers and Page Messages in Cross Lane
Mode,” page 47.
Installer Setup
Installer setup is a special group of setup options typically only used by the
installer or in case of complete system restoration or backup.
Load Installation Settings
Installation settings are a complete set of configuration data that the installer can
save after the initial installation configuration is completed. It is essentially a
backup save point in case configuration settings are inadvertently changed in
ways that are not easy to identify or correct.
To load the installation settings:
Important Note:
By performing this procedure you will be erasing the current configuration
and reloading the configuration that was last saved, likely when the system
was first installed.
• Enter the configuration mode, see page 34.
• Select 14 Installer Setup .
• Change the value for Load Installation Settings to Yes .
Save Installation Settings
Note:
This function is only available to installers.
Perform the following procedure to save the current configuration into
permanent memory over the existing installation settings.
Important Note:
By performing this procedure you will be erasing the existing saved
installation settings, making it impossible to revert to the settings that were
saved after installation.
• Enter the configuration mode, see page 34.
• Select 14 Installer Setup .
• Change the value for Save Installation Settings to Yes .
Technical Service Message
Perform the following procedure to customize the Service Screen message.
• Enter the configuration mode, see page 34.
• Select 14 Installer Setup .
• Change the value for Use Custom Tech Service Message? to Yes
or No .