Installation Manual

Configuration
April 24 2015 – Revision 1.0
Page 52 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
You can integrate any 3M approved external device that can be operated by
opening or closing a switch and is independent of the intercom system, to
receive a signal (OUT).
The choices are:
- TALK_1 – TALK channel (Outbound) open on Lane1
- TALK_2 – TALK channel (Outbound) open on Lane2
- PAGE_1 – PAGE channel open on Lane1
- PAGE_2– PAGE channel open on Lane2
- GRT_CNCL_1 – Activate/Stop message playing on external Greeter for
Lane1
- GRT_CNCL_2– Activate/Stop message playing on external Greeter for
Lane2
- VEH_DET_1 – Vehicle detected at Lane1 Order Point
- VEH_DET_2 – Vehicle detected at Lane2 Order Point
- Any GPIOs that are currently configured as INPUTS to the basestation
(receive a signal or IN)
Perform the following procedure to set up and/or reassign any GPIOs:
• Enter the configuration mode, see page 34.
• Select 12 Digital IO Setup
• Use , , ⊳, and  as necessary to scroll to the desired IO #.
• Change the value for the field IN/OUT and choose the appropriate
Signal by scrolling down the list presented on the screen
(Press , , ⊳, and  to scroll up and down the list).
• At each step press Enter to implement the change or press Mode to
abandon the change and retain its original value.
Change Passcodes
User and installer passcodes can be individualized for better security control
against unauthorized changes. The system has a default user and a default
installer passcode pre-installed. Check your documentation for those passcodes.
User Passcodes
If you enter a user passcode, you have full access to the Change User Passcodes
menu. You can change or delete any passcode.
Perform the following procedure to set up and/or change user passcodes:
• Enter the configuration mode, see page 34.
• Select 13 Change Passcodes > Change User Passcodes .
• Identify the user number you want to change, then press , , ⊳, and
 as necessary to scroll to the desired passcode.
• Enter a new four-digit passcode in place of the old passcode.
• Press Enter to implement the change or press Mode to abandon the
change and leave the passcode at its previous setting.
Split and Cross Lane Mode
In any dual lane installation (tandem, side-by-side, or dual drive thrus), the
system can be configured to operate registered headsets in Split or Cross Lane
Mode. The difference between split lane and cross lane modes in this situation
is: