Installation Manual

Configuration
April 24 2015 – Revision 1.0
Page 50 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
• Enter the base station configuration mode, see page 34.
• Change the value for 07 Global Settings > Blue LED
Alerts on Headsets to YES or NO .
Order Taking Modes Setup
Perform the following procedure to enable or disable some of the seven different
order taking modes from appearing on the Run Menu:
• Enter the base station configuration mode, see page 34.
• Navigate to 09 O.T. Modes Setup .
• Change the value for each of the following options to Yes or No :
• Manual Listen/Push To Talk
• Manual Listen/Manual Latching Talk
• Auto Listen/Push To Talk
• Auto Listen/Manual Latching Talk
• Hands Free
• Outside
• Always On (Bypass Vehicle Detector)
(Press  or  to scroll up and down the list)
Notes:
Order taking modes are described in the Operation section.
3M recommends you do not set up more than three order taking modes.
Change Site Scheduling
The site schedule is the calendar of store open and closing times.
Note:
All timekeeping is done using a 24 hour clock (e.g., 6:00 p.m. appears as
18:00).
Regular Site Schedule
The regular site schedule is the opening and closing times for each day of the
week and the times assigned as “Day” and “Night,” which determine when the
day and night volume settings change.
Perform the following procedure to set the regular site schedule:
• Enter the base station configuration mode, see page 34.
• Navigate to 10 Site Scheduling > Regular Site Schedule .
• Change the value for each day of the week and each of the four defined
fields ( Open , Day , Night , and Close ).
(Press , , ⊳, and  to scroll up and down the list).
Note:
The greeter will not play messages while the store is closed, except for the
(built-in or custom) store closed message.