Installation Manual

Configuration
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 49 of 76
Important Notes:
By default, the Kitchen Noise Reduction is set to DYNAMIC.
For this feature to function, all “signed-on” headsets must be of version 5.12 or later.
If even one headset of an older version signs on, the:
feature will automatically be disabled despite it’s value remaining set as DYNAMIC
base station emits 3 audible chirps and
Run Screen will display a message
“ Headset <XXXXXXX> allows kitchen noise ”.
In the event the Kitchen Noise Reduction feature has been disabled due to a
headset with an older version of software having signed on, use the base
station’s menu to identify and remove the offending headset(s) before restarting
the base station, in order to restore the feature.
1. Identify and write down the serial number of the headset or headsets that
have a software version 5.12 and lower by performing the following steps
• Enter the base station configuration mode, see page 34.
• Navigate to 08 Headset Setup > Currently Editing Headset .
• Press ⊳ or  if necessary to scroll through the headsets. The
software version appears below the headset ID number.
2. Unregister the headset(s) identified above by performing the following
steps
• Enter the base station configuration mode, see page 34.
• Select 04 Registration > 2 Remove Headsets .
• Scroll to the number of the headset you want to un-register.
• Press Enter.
3. Rebooting the base station will now restore the Kitchen Noise
Reduction feature.
Haptics “Vibration” Alerts and Blue LED Alerts on Headsets
These options allow you to enable the G5 headset to
- Gently vibrate and/or
-Flash a Blue LED (at the tip of the mic boom)
when a vehicle is detected at the Order Point
These options are, by default, set to YES.
This option only applies to G5 headsets.
If you currently have no G5 headsets and only XT-1 headsets, then enabling or disabling
this option will not affect the normal functioning of the XT-1 headset.
Haptics “Vibration” Alerts on Headsets
Perform the following procedure to enable or disable the Haptics “Vibration” Alerts
on the Headset upon a vehicle detect at the Order Point
• Enter the base station configuration mode, see page 34.
• Change the value for 07 Global Settings > Vibe Alerts on
Headsets to YES or NO .
Blue LED Alerts on Headsets
Perform the following procedure to enable or disable the Blue LED Alerts on the
Headset upon a vehicle detect at the Order Point