Installation Manual

Configuration
April 24 2015 – Revision 1.0
Page 48 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
Order Point TALK with No Vehicle
Perform the following procedure to permit or prevent the order taker to talk to
the order point when no vehicle is detected.
• Enter the base station user service mode, see page 34.
• Change the value for 07 Global Settings > Order Point TALK
With No Vehicle? to Yes or No .
Detector Type
Because there are two basic types of vehicle detector, pulse and presence, you
must specify which type you have in the base station.
• Enter the base station configuration mode, see page 34.
• Change the value for 07 Global Settings > Vehicle
Detector#1 to Presence or Pulse .
Note:
Press the Lane button to configure Detector#2 on Lane2
• For presence type detectors, specify a value for Vehicle Detector
#X Minimum (Seconds) . Setting a higher number will increase the
customer’s wait time, but decrease false detections that could be caused
by cars driving over the detector without stopping.
Notes:
When the pulse setting is used, each call must be ended by pressing the page
button on the headset.
If you are using a vehicle detector board, the presence or pulse setting should
match the dip switch setting on the board.
If the vehicle detector is set to delay (via its own dip switches) and you set a
delay in the base station, the delays are additive: you could end up with a
longer than expected total delay.
Kitchen Noise Reduction
Activating this option reduces the amount of background kitchen noise picked
up by the order takers headset microphone and transmitted to the order point
speaker.
Perform the following procedure to enable or disable Kitchen Noise Reduction.
• Enter the base station configuration mode, see page 34.
• Change the value for 07 Global Settings > Kitchen Noise
Reduction to DYNAMIC or OFF .