Installation Manual
Configuration
April 24 2015 – Revision 1.0
Page 44 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
• Select
04 Registration
>
2 Remove Headsets
.
• Scroll to the number of the headset you want to un-register.
• Press Enter.
Note:
If you do not know or have access to the number of the headset to be un-
registered, identify the headsets that you want to remain in service and un-
register any that remain on the list.
List All Headsets
To see a list of the registered headsets:
• Enter the base station configuration mode, see page 34.
• Select
04 Registration
>
3 List All Headsets
.
Resetting Inactive Days
For any headset, you can manually reset its number of inactive days to zero
To reset the inactive days:
• Enter the base station configuration mode, see page 34.
• Navigate to
08 Headset Setup
>
Currently Editing Headset
.
• Press ⊳ or if necessary to scroll to the headset ID number for the
headset you want to reset.
• Select
<CLEAR>
.
Checking Headset Software Revision
To check the software revision number for a headset:
• Enter the base station configuration mode, see page 34.
• Navigate to
08 Headset Setup
>
Currently Editing Headset
.
• Press ⊳ or if necessary to scroll through the headsets. The software
version appears below the headset ID number.
Change Noise Reduction Level
There are several ways to improve the sound quality at the headset using the
following settings.
Inbound Microphone Noise Reduction Level
The inbound microphone noise reduction level setting reduces background noise
to make it easier to hear speech at the customer order point.
Perform the following steps to increase or decrease the noise reduction level.
• Enter the base station configuration mode, see page 34.
• Make a new selection for
05 Noise Reduction
>
Inbound Mic
Noise Reduction Level
. Options are
Off
,
Min
,
Low
,
Med
,
Hi
, and
Max
. You may need to experiment for a setting that works best for
your ambient noise environment.
Acoustic Echo Canceller
Perform the following procedure if there is a delayed repetition (echo) of the
outbound sound:
• Enter the base station configuration mode, see page 34.