Installation Manual

Installation
April 24 2015 – Revision 1.0
Page 22 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
Note:
The steps below assume that all of the communication cabling has been
prepared and is available at the base station. If not, see “
Base Station to Component Wiring,” page 25.
• Follow local best practices and any applicable regulations to route the
cables into the base station cabinet’s top, sides, or back (through the
wall) as neatly as possible. Do not route power supply wiring with
communication wiring in the same conduit.
• Attach all cables to their appropriate terminals.
• Connect the base station transformer between the wall outlet and the
base station power supply connection.
Connect the Components
This section provides diagrams and information that should help you to properly
wire the system components together.
Base Station Wiring Terminal Identification
Figure 7 identifies all of the wiring terminals and their labels. The table that
follows provides definitions of the labels and identifies where they should be
connected in the system.