Installation Manual

Installation
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 21 of 76
• Lift the cover upward and away. The display and keypad remain with
the base, not with the cover.
To replace the base station cover:
• Verify there are no obstructions (tools, etc.) in the way of the cover
being closed.
• Align the top edge of the cover with the base.
• Swing the bottom half of the cover down into place and gently push it
against the base until it locks into place. Tighten the two screws
located at the bottom of the cover.
Mount the Station
Perform the following procedure to install the base station (See Figure 6).
• Remove the base station cover:
Figure 6
• Attach the base station to the wall using screws and possibly wall
anchors.