Installation Manual

Installation
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 17 of 76
For information on wiring and configuring the vehicle detector(s) to the base
station see “
Base Station to Component Wiring,” page 25.
For information on installing the vehicle detector circuit boards in the base
station, see “
Installing Accessory Boards in the Base Station” on page 29
Assemble the 3M™ Drive Thru Headset G5
The components that make up a 3M™ Drive Thru Headset G5 are packaged and shipped
as individual parts:
3M™ Control Pod, G5 (includes a pack of ID Tags)
3M™ Carrier, G5 (includes a pack of ID Tags) and
3M™ Battery, G5
Use the instructions below to assemble these parts to make a fully functional headset.
Installing ID Tags
In 3M
TM
drive-thru systems with Reminder and Alert features in V5 release software
installed, you can (by installing ID tags on each headset ) easily
- Assign and identify headsets to crew members
- Attend to hygiene concerns
Each Control Pod and Carrier shipped has a bag enclosed with 8 different colored tags
that can be interchanged by the staff. The Control Pod and Carrier come pre-installed
with Black ID Tags. The colors included in the bag are: