Installation Manual

Installation
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 15 of 76
Notes:
Power plugs are available on both sides of the stand-alone Battery Charger, G5,
12-slot to allow a connection to one additional Battery Charger, G5, 12-slot or a
Headset Charging Station, G5 in serial using a patch cable.
You may also use the power plug on the last charger in the interconnected chain
to supply power to the basestation.
Notes: Wall mounting
Both types of battery chargers can be mounted on the wall. Due to the many
different wall types available, hardware is not included. Hardware or anchors
used for wall mounting must be suitable for the wall type, and be capable of
supporting a 2.9lb/1.3kg minimum load for the 3M™ Drive-Thru Headset
Charging Station, G5, and a 1.3lb/0.6kg minimum load for the 3M™ Drive-thru
Headset Battery Charger, G5 12-slot.
XT-1 6-slot or 3-slot battery charger.
Perform the following steps to install and use the 6-slot or 3-slot battery charger
(see Figure 5).
Figure 5
• Select a placement location:
 A flat, dry surface such as a desktop or shelf.
 An easy-to-reach wall location if you have the optional wall-mount
bracket.
• The power cord should be in place where it cannot be pinched or bent
• Install the wall-mount bracket on the wall, if applicable.
• Place the charger on the wall-mount bracket or surface.
• Connect the power supply transformer between the wall receptacle and
the charger. The charge indicator lights will flash.
• Insert each battery to be charged into a slot on the charger. The charge
indicator lights for each slot will light steadily red to indicate that the
battery is charging or green to indicate that the battery is fully charged.
Three-Slot Charger
Six-Slot Charger
Power Supply Transformers