Installation Manual

Installation
April 24 2015 – Revision 1.0
Page 14 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
• When charging is complete, the batteries are ready for use.
3M
TM
Drive-Thru Headset Charging Station, G5:
Headset Charging Station, G5 uses the same power adapter as the basestation.
Perform the following steps to install and use the Headset Charging Station, G5
• Select a placement location, either
 A flat, dry surface such as a desktop or shelf.
 An easy-to-reach wall.
• The power outlet must be near the equipment and be accessible, and
cord placed where it cannot be pinched or bent.
• If wall mounting is to be used: Due to the many different wall types
available, hardware is not included. Secure the product to the wall with
anchors suitable for the type of wall, and which can support a
2.9lb/1.3kg minimum load.
• Place the charger on the surface.
• Connect the 3M supplied power adaptor between the wall receptacle
and the charger.
• Insert a G5 Headset (with a G5 battery in it) into the Headset bay on the
charger.
Alternatively, you may insert the G5 battery to be charged into a slot on
battery bay of the charger.
• The LED lights on the battery will light up indicating the level of
charge. Each LED indicates a charge of 25%. When all LEDS are lit
green, the battery is fully charged.
• When charging is complete, the batteries are ready for use.