SDS

3M™ Hi-Strength Spray Adhesive 90 02/26/16
__________________________________________________________________________________________
Page 4 of 12
Irritant Vapors or Gases During Combustion
5.3. Special protective actions for fire-fighters
No special protective actions for fire-fighters are anticipated.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Ventilate
the area with fresh air. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the spill
area to burn or explode. Refer to other sections of this SDS for information regarding physical and health hazards, respiratory
protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
If possible, seal leaking container. Place leaking containers in a well-ventilated area, preferably an operating exhaust hood, or
if necessary outdoors on an impermeable surface until appropriate packaging for the leaking container or its contents is
available. Close cylinder. Collect as much of the spilled material as possible using non-sparking tools. Place in a metal
container approved for transportation by appropriate authorities. Dispose of collected material as soon as possible.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not use in a confined area with minimal air exchange. Keep out of reach of children. Keep away from heat/sparks/open
flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after
use. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke
when using this product. Wash thoroughly after handling. Avoid release to the environment. Avoid contact with oxidizing
agents (eg. chlorine, chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures
exceeding 50C/122F. Store away from heat. Store away from acids. Store away from oxidizing agents.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limits
If a component is disclosed in section 3 but does not appear in the table below, an occupational exposure limit is not available
for the component.
Ingredient C.A.S. No. Agency Limit type Additional Comments
Pentane 109-66-0 OSHA TWA:2950 mg/m3(1000 ppm)
Pentane 109-66-0 ACGIH TWA:1000 ppm
Cyclohexane 110-82-7 OSHA TWA:1050 mg/m3(300 ppm)
Cyclohexane 110-82-7 ACGIH TWA:100 ppm
Dimethyl Ether 115-10-6 AIHA TWA:1880 mg/m3(1000 ppm)
Dimethyl Ether 115-10-6 CMRG TWA:1000 ppm
1,1-Difluoroethane 75-37-6 AIHA TWA:2700 mg/m3(1000 ppm)
1,1-Difluoroethane 75-37-6 CMRG TWA:1000 ppm
Methyl Acetate 79-20-9 OSHA TWA:610 mg/m3(200 ppm)
Methyl Acetate 79-20-9 ACGIH TWA:200 ppm;STEL:250 ppm