Datasheet

EU_Master_01
3M is a trademark of 3M company.
Please recycle. © 3M 2014.
All rights reserved.
17430
Personal Safety Division
EMEA Region
3M Centre,
Cain Road, Bracknell
Berkshire RG12 8HT
United Kingdom
Tel: [phone]
www.3M.eu/safety
Disposal
Contaminated products should be disposed as hazardous waste in
accordance with national regulations.
Cleaning
If the respirator is to be used for more than one shift the faceseal/
gasket must be cleaned at the end of each shift using the 3M™
105 face seal wipe. DO NOT immerse product in water. Store
cleaned respirator in clean, airtight container.
Warnings and Limitations
• Always be sure that the complete product is:
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
• Proper selection, training, use and appropriate maintenance
are essential in order for the product to help protect the wearer
from certain airborne contaminants.
• Failure to follow all instructions on the use of these respiratory
protection products and/or failure to properly wear the
complete product during all periods of exposure may adversely
affect the wearer’s health, lead to severe or life threatening
illness or permanent disability.
• For suitability and proper use follow local regulations and refer
to all information supplied. For more information contact a
safety professional/3M representative.
• Before use, the wearer must be trained in use of the complete
product in accordance with applicable Health and Safety
standards/guidance.
• These products do not contain components made from natural
rubber latex.
• These products do not protect against gases/vapours.
• Do not use in atmospheres containing less than 19.5% oxygen.
(3M definition. Individual countries may apply their own limits
on oxygen deficiency. Seek advice if in doubt).
• Do not use for respiratory protection against atmospheric
contaminants/concentrations which are unknown or
immediately dangerous to life and health (IDLH).
• Do not use with beards or other facial hair that may
inhibit contact between the face and the product thus
preventing a good seal.
• Leave the contaminated area immediately if:
a. Breathing becomes difficult.
b. Dizziness or other distress occurs.
c. The respirator becomes damaged
d. You taste or smell contaminants, or an irritation occurs
• Discard and replace the respirator if it becomes damaged,
breathing resistance becomes excessive or at the end of the
shift.
• Do not alter, modify, clean or repair this respirator.
• In case of intended use in explosive atmospheres, contact 3M.
• Before initial use, always check that the product is within the
stated shelf life (use by date).
Important Notice
3M does not accept liability of any kind, be it direct or consequential (including, but not limited to, loss of profits, business and/or goodwill)
arising from reliance upon any information herein provided by 3M. The user is responsible for determining the suitability of the products for
their intended use. Nothing in this statement will be deemed to exclude or restrict 3M’s liability for death or personal injury arising from its
negligence.