SDS

3M(TM) Rubber & Vinyl 80 Spray Adhesive 03/30/15
__________________________________________________________________________________________
Page 5 of 13
Rosin 8050-09-7 ACGIH Limit value not established: Cntrl all exposr-low as
possib,
Dermal/Respiratory
Sensitizer
ACGIH : American Conference of Governmental Industrial Hygienists
AIHA : American Industrial Hygiene Association
CMRG : Chemical Manufacturer's Recommended Guidelines
OSHA : United States Department of Labor - Occupational Safety and Health Administration
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Do not remain in area where available oxygen may be reduced. Use general dilution ventilation and/or local exhaust
ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapors/spray.
If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Indirect Vented Goggles
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing.
Gloves made from the following material(s) are recommended: Nitrile Rubber
Respiratory protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Full facepiece air-purifying respirator suitable for organic vapors
Organic vapor respirators may have short service life.
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
General Physical Form:
Liquid
Odor, Color, Grade:
Clear to Yellow sweet fruity
Odor threshold
No Data Available
pH
Not Applicable
Melting point
Not Applicable
Boiling Point
Not Applicable
Flash Point
-42 ºF [Test Method: Tagliabue Open Cup]
Evaporation rate
1.90 [Ref Std: ETHER=1]
Flammability (solid, gas)
Not Applicable