MSDS

3M MATERIAL SAFETY DATA SHEET 3M(TM) Super 77(TM) Multipurpose Adhesive (Aerosol) 04/30/2007
dikes to prevent entry into sewer systems or bodies of water. If possible, seal leaking container. Place leaking containers in a well-
ventilated area, preferably an operating exhaust hood, or if necessary outdoors on an impermeable surface until appropriate packaging
for the leaking container or its contents is available. Cover spill area with a fire-extinguishing foam. An aqueous film forming foam
(AFFF) is recommended. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent material does
not remove a toxic, corrosivity or flammability hazard. Collect as much of the spilled material as possible using non-sparking tools.
Clean up residue with an appropriate organic solvent. Read and follow safety precautions on the solvent label and MSDS. Collect the
resulting residue containing solution. Place in a metal container approved for transportation by appropriate authorities. Seal the
container. Dispose of collected material as soon as possible.
In the event of a release of this material, the user should determine if the release qualifies as reportable according to
local, state, and federal regulations.
SECTION 7: HANDLING AND STORAGE
7.1 HANDLING
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Keep away from heat,
sparks, open flame, pilot lights and other sources of ignition. Ground containers securely when transferring contents. Wear low static
or properly grounded shoes. Do not pierce or burn container, even after use. No smoking while handling this material. Do not spray
near flames or sources of ignition. Avoid breathing of vapors, mists or spray. Avoid static discharge. Avoid eye contact with vapors,
mists, or spray. Keep out of the reach of children. Vapors may ignite explosively. May cause flash fire. Prevent build-up of vapors -
open all windows and doors. Maintain vapor concentrations below recommended exposure limits. Use only with cross-ventilation.
Without adequate ventilation, vapors may settle in low-lying areas. Keep away from heat, sparks, and open flame. Do not smoke or
ignite matches, lighters, etc. Do not breathe vapors. Avoid contact with oxidizing agents.
7.2 STORAGE
Store away from acids. Store away from heat. Store out of direct sunlight. Keep container tightly closed. Do not store containers on
their sides. Store away from oxidizing agents.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Use in an enclosed process area is recommended. Do not use in a confined area or areas with little or no air movement. Do not
remain in area where available oxygen may be reduced. Use general dilution ventilation and/or local exhaust ventilation to control
airborne exposures to below Occupational Exposure Limits and/or control mist, vapor, or spray. If ventilation is not adequate, use
respiratory protection equipment. Do not use in a confined area or areas with little or no air movement. If exhaust ventilation is not
adequate, use appropriate respiratory protection. Provide ventilation adequate to control vapor concentrations below recommended
exposure limits and/or control spray or mist.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact with vapors, mists, or spray.
The following eye protection(s) are recommended: Indirect Vented Goggles.
8.2.2 Skin Protection
Avoid skin contact.
Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment. Consult with
your glove and/or protective clothing manufacturer for selection of appropriate compatible materials.
Gloves made from the following material(s) are recommended: Fluoroelastomer (Viton), Nitrile Rubber, Polyvinyl Alcohol (PVA),
_________________________________________________________________________________________________
Page 4 of 9