User Manual

NA - ENG
April 2016
3M-Matic
™
7000r-7000r3 Pro
Page 39
12.1 Operator’s Working Position and
Operational Flow (Figure 12-1).
Once the box has been  lled,
close its top  aps and push it
between the top and bottom
drive belts. Always keep hands
in position as shown in Figure 12-2.
The box will be automatically sealed
with adhesive tape on top and bot-
tom box seams. Then the box will
be expelled on the exit conveyor.
12.2 Starting the Machine
Important: Before starting the
machine, verify that no tools
or objects are on conveyor bed.
Let the machine run without cartons
and check its safety devices. Then
start the working cycle.
12.3 Starting Production
After adjusting machine to box
dimensions (height-width), let
machine run without cartons and
check safety devices. Then start
working cycle.
12.4 Tape Replacement and Threading
See Manual 2 or 3: AccuGlide™ 3
Taping Heads - 2 Inch or 3 Inch.
Press the LATCHING EMERGENCY
STOP BUTTON.
12.5 Box Size Adjustment
Repeat all the operations shown in
Section 11 - Set-Up/Adjustments.
12.6 Cleaning
Before carrying out cleaning or
maintenance operation, stop the
machine by turning OFF (O) switch
on main and disconnect pneumatic
and electric power (Figure 12-3).
12.7 Table of Operation Adjustments -
Operator Quali cations
1 Tape loading and threading 1
2 Tape web alignment 1
3 Adjustment of one way tension roller 1
4 Adjustment to box size (H and W) 1
5 Top  ap compression rollers 1
6 Adjustment of tape applying spring 1
7 Conveyor bed height adjustment 1
8 Special Adjust-Changing tape leg 2
9 Special Adjust-Column re-position 2
12.8 Safety Devices Inspection
1. Taping units blade guard
2. Latching emergency stop button
3. STOP (OFF) (O) main switch
Hand
Position
Figure 12-1
Figure 10-1
Figure 12-5 Figure 12-4
E-Stop
"Start/Stop"
12. Operation
Figure 12-2
Figure 12-3
"On-O "