User Manual

NA - ENG
April 2016
3M-Matic
™
7000r-7000r3 Pro
Page 25
Figure 7-9 Infeed Conveyor
Figure 7-10 Cover Plates
Figure 7-11 Centering Guides
A
B
Figure 7-8
Lower
Taping
Head
Mounting
7.7 Infeed Conveyor Assembly
1. Remove the conveyor and the
package of parts from the carton.
2. Verify that package contains two
right angled cover plates, twelve (12)
M8 × 15 hex head screws, and
eight (8) M8  at washers.
3. To assemble the infeed conveyor,
refer to Figure 7-9 and locate
four (4) bolt holes on the infeed
end of the case sealer frame.
4. Insert a M8 × 15 screw in each
hole so that only a few threads
take hold. Do not use washers
with these screws.
5. Attach the infeed conveyor over the
screws using the inverted keyholes
in the end of the conveyor.
Tighten all four (4) screws with a
13mm wrench.
6. Refer to Figure 7-10. Set the cover
plates over the joint between the
conveyor and the frame on each
side and secure them with four (4)
M8 × 15 screws and M8 washers.
7.8 Centering Guides
1. Remove the two centering guides
and four (4) M6 × 20 socket head
screws from the package.
2. Using a 5mm hex key wrench,
attach the centering guides to the
rails with four (4) M6 × 20 screws
(two [2] in each guide) as shown in
Figure 7-11.
7.9 Outboard Tape Roll Mounting
(Lower Taping Head)
Remove the tape drum bracket
assembly, spacer and fasteners from
the lower taping head. Install and
secure on the infeed end of lower
frame (as shown in Figure 7-8).
7.10 Tape Leg Length
Taping heads are pre-set to apply
70mm [2.75 inch] long tape legs.
To change tape leg length to
50mm [2.0 inch], see “Special Set-
Up Procedure – Changing the
Tape Leg Length.”
7. Installation (continued)