User Manual

NA - ENG
April 2016
3M-Matic
™
7000r-7000r3 Pro
Page 21
Figure 7-2
Figure 7-1
7.1 Operating Conditions
The machine should operate in a
dry and relatively clean environment
(See Speci cations).
7.2 Space Requirements for
Machine Operation and
Maintenance Work
Minimum distance from wall
(Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
7.3 Tool Kit Supplied with Machine
A tool kit containing some tools are
supplied with the machine. These
tools should be adequate to set-up
the machine, however, other tools
supplied by the customer will be
required for machine maintenance.
7.4 Machine Set-Up / Bed Height
1 - Lift the machine with belts or
ropes paying attention to place
the belts in the points
(Figure 7-2).
To set the machine bed height,
do the following:
2 - Adjust machine bed height.
The case sealer is equipped
with four (4) adjustable legs
that are located at the corners
of the machine frame.
The legs can be adjusted to
obtain di erent machine bed
heights (Figure 7-3).
Also refer to “Speci cations”
3 - Lock the screws.
4 - Repeat the operation for all legs.
(It is not necessary to  x or
anchor the machine to the  oor).
5 - For Outer Column Reposition-
ing-
See Special Set-up Procedure
(Section 11).
Figure 7-3
B
A
7. Installation