Datasheet
3M
™
Reusable Half Masks 6500QL Series
IMPORTANT NOTICE
The use of the 3M product described within this document assumes that the user has previous experience of this type of product and that it will be used
byacompetent professional. Before any use of this product it is recommended to complete some trials to validate the performance of the product within its expected
application.
All information and specification details contained within this document are inherent to this specific 3M product and would not be applied to other products
orenvironment. Any action or usage of this product made in violation of this document is at the risk of the user.
Compliance to the information and specification relative to the 3M product contained within this document does not exempt the user from compliance with additional
guidelines (safety rules, procedures). Compliance to operational requirements especially in respect to the environment and usage of tools with this product must
beobserved. The 3M group (which cannot verify or control those elements) would not be held responsible for the consequences of any violation of these rules which
remain external to its decision and control.
Warranty conditions for 3M products are determined with the sales contract documents and with the mandatory and applicable clause, excluding any other warranty
or compensation.
Respiratory protection is only effective if it is correctly selected, fitted and worn throughout the time when the wearer is exposed to respiratory contaminants.
3Moffers advice on the selection of products, and training in the correct fitting and usage.
For more information on 3M products and services please contact 3M.
Cleaning and storage
1. Disassemble by removing the filters, head straps and
other parts.
2. Clean and sanitise the mask (excluding filters) using
3M
™
105 Face Seal Cleaner or immersing in warm cleaning
solution and scrubbing with a soft brush until clean.
Parts may also be cleaned in a domestic washer.
3. Disinfect respirator by soaking in a solution of quaternary
ammonium disinfectant or sodium hypochlorite
(30ml household bleach in 7.5l of water) or other disinfectant.
4. Rinse in fresh, warm water and air-dry in non-contaminated
atmospheres.
Water temperature should not exceed 50°C.
Do not use cleaning agents that contain lanolin or other oils.
Do not autoclave.
Materials
Part Description
Faceseal Silicone rubber
Over mould Nylon
Inhalation valve Polyisoprene
Exhalation valve Nylon/silicone
Straps Polyester fibre/polyurethane elastic
Head cradle Polyethylene
Buckles Polypropylene
Spare parts
Part Description
6582 Rugged comfort QL cradle
6583
Rugged comfort exhalation
valve
6893 Inhalation valve
Shelf life
Shelf life*: 5 year from production date when stored at storage conditions
described on packaging.
*The shelf life as defined above remains a indicative and maximum data,
subject to many external and non-controllable factors. It may never
beinterpreted as a warranty.
3M Ireland Limited
The Iveagh Building
The Park, Carrickmines
Dublin 18
t: 1 800 320 500
Personal Safety Division
3M United Kingdom PLC
3M Centre
Cain Road, Bracknell
Berkshire RG12 8HT
t: 0870 60 800 60
www.3M.co.uk/PPEsafety
Please recycle. Printed in the UK. © 3M 2022. 3M is a trademark
of3M Company. All rights reserved. 2022.v1]