Cut Sheet

3.2 Kit Contents:

• Elbow Body

• Coppertop Compression Connector

• Loadbreak Probe

• Probe Installation Tool

• Silicone Lubricant

• Cold Shrink

™

Jacketing Tube

• Mastic Strips (3 ea.)

• Ground Braid Assembly

• Constant Force Spring

• CC-3 Cable Cleaning Pads

• Installation Instructions

The 5810-CA and 5810-CB Series kits contain the

following additional materials:

• Cable Adapter

• Silicone Lubricant

• Supplemental Installation Instructions

4.0 Availability

The 3M

™

5810 Series Industrial Loadbreak elbow kit is

available for connecting 5, 8 and 15 kV shielded power

cables to ANSI/IEEE 386 loadbreak bushings. The

200 Amp elbow is designed for use with tape shield, wire

shield, UniShield

and concentric neutral cable types.

The kits are available from your local authorized 3M

electrical destributor.

3M is a registered trademark of 3M.

UniShield

is a registered trademark of BICC Cables.

IMPORTANT NOTICE

Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability

associated with such use.

Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture as of the date of

purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above,

your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except

where prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product, whether direct, indirect, special,

incidental or consequential regardless of the legal theory asserted.

Electrical Products Division

6801 River Place Blvd.

Austin, TX 78726-9000

www.3M.com/elpd

Litho in USA