Submittal Sheet
3M
™
Water Filtration ProductsESP114-T & ESP124-T
SPEC#
QUANTITY
MODEL NUMBER
PART NUMBER
PHYSICAL SPECIFICATIONS
• System includes a head assembly, integral mounting bracket, and single cartridge fi lter.
• Optional downstream pressure gauge port in top of head assembly.
• Inlet and outlet plumbing connections are 3/8” FNPT.
• System incorporates an internal automatic 1/4 turn shut-off valve.
• Filter cartridges are o-ring seal type.
• System maximum operating pressure of 125 psi (862 kPa) and operating tempera-
tures of 100°F (37.8°C).
• Recommended service fl ow rate is 0.5 gpm (1.9 lpm).
• Filter cartridges incorporate premium activated carbon media and strong-acid ion-
exchange media in the sodium form.
• System materials are FDA CFR-21 and/or NSF compliant.
• Cartridge body is constructed from high-impact polypropylene.
• Cartridges are sanitary in design, requiring no contact with the fi lter media during
cartridge change-out.
• Filter cartridges requires no pre-activation.
• Shipping weight: ESP114-T — 20 lbs. (9.1 kg) per case
ESP124-T — 12 lbs. (5.44 kg) per case
• Case Quantity: ESP114-T — 6
ESP124-T — 4
These installation tips are for informational purposes only and are not intended to be
used as actual installation instructions. CAUTION: To reduce the risk associated with
property damage due to water leakage:
• Read and follow Use Instructions before installation and use of this system.
• Installation and use MUST comply with all state and local plumbing codes.
• Protect from freezing, remove fi lter cartridge when temperatures are expected to drop
below 40°F (4.4°C).
• Do not install on hot water supply lines. The maximum operating water temperature
of this fi lter system is 100°F (37.8°C).
• Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure
exceeds 80 psi (552 kPa), you must install a pressure limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions
exist you must install a water hammer arrester. Contact a plumbing professional if you are
uncertain how to check for this condition.
• The disposable fi lter cartridge MUST be replaced every 12 months, at the rated capacity
or if a noticeable reduction in fl ow rate occurs.
WARNING: To reduce the risk associated with the ingestion of
contaminants:
• Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
CUNO Incorporated recommends regularly scheduled maintenance and
replacement of the fi lter cartridge(s) in order for the product to perform
as advertised/sold. CUNO shall not be liable for system failures due to
improper maintenance.
3M is trademark of 3M Company.
NSF is a trademark of NSF International.
© 2008 3M Company. All rights reserved.
LITFS303 1210P
70-0201-9429-9
IMPORTANT: INSTALLATION TIPS
CUNO Incorporated
400 Research Parkway
Meriden, CT 06450 U.S.A.
Toll Free: 1.800.222.7880
Worldwide: 203.237.5541
Fax: 203.238.8701
www.cuno.com
LIMITED WARRANTY
CUNO Incorporated warrants this Product (excluding disposable fi lter cartridge(s)) to be free from defects in material and workmanship for fi ve (5) years from the date of
purchase. The disposable fi lter cartridge is warranted from defects in material and workmanship for a period of one (1) year from the date of purchase. This warranty
does not cover failures resulting from abuse, misuse, alteration or damage not caused by CUNO or failure to follow installation and use instructions. If the Product is defec-
tive CUNO will replace the Product or refund your Product purchase price. CUNO will not be liable for any indirect, special, incidental, or con-sequential damages arising
from the use of this Product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. To
obtain warranty service, mail your request to Warranty Claims, CUNO Incorporated, 400 Research Parkway, Meriden, CT 06450. Proof of purchase (original sales receipt)
must accompany the warranty claim, along with a complete description of the Product, model number and alleged defect. This warranty gives you specifi c legal rights and
you may have other rights which vary from state to state, or country to country.
4"
(10.2 cm)
15.5"
(39.4 cm)
3" (7.6 CM) MIN REQUIRED
FOR CARTRIDGE REMOVAL
4"
(10.2 cm)
19 3/4"
(50.2 cm)


