Operating instructions

4
3M™ International Electronic/Service Vacuum Operating Instructions
© 3M 2009
To Store Attachments
for Transport
To Replace Filter
1. Unplug the power cord from the
outlet and the vacuum.
2. Open the lid and retrieve the L-15X
filter plug.
3. Remove the hose from the inlet and
insert the L-15X filter plug.
4. Detach the hose nozzle from the base.
5. Place the hose, power cord and
attachments into the lid and close the
accessory door.
6. Close the lid and securely fasten the
latches.
The 3M
™
Vacuum is designed for use
with disposable 3M™ Filters. The 3M
Filters must be replaced on a regular
basis. Frequency of lter replacement
depends on the type and frequency of
use of the Service Vacuum.
1. Release the latches and open the lid.
2. Remove either the L-15X lter plug
or hose. Save the plug for use later
(see note below).
3. Grasp the lter and pull it straight up.
4. Insert the L-14X lter plug in the
lter.
5. Dispose of the lter in a suitable
manner.
6. Remove the L-14X plug from the new
lter and position lter in the vacuum
with the lter hole to your left. Save
the L-14X plug for use in disposing
the lter (see note below).
7. Verify that the gasket between the
lter and the motor ts tightly.
8. Insert the L-15X lter plug or hose.
9. Close and latch the lid.
Note: The L-15X plug (longer plug) is
used to cover the lter inlet for storage
when the vacuum cleaner is not in use.
This plug comes with the lter in a
new vacuum cleaner. The L-14X plug
(shorter plug) is used to cover the lter
inlet for disposal. This plug comes with
each new replacement lter.
ELECTRIC SHOCK COULD
OCCUR IF USED OUTDOORS
OR ON WET SURFACES!
Do not operate when filter
is full. A lack of suction or
exhaust is an indication of a
full filter.
To avoid risk of fire, filter
must be installed properly
and replaced regularly. Do
not open filter, reuse filter or
attempt to replace components
within filter.
WARNING
!
CAUTION
!
CAUTION
!
Vacuum Guide_REVISION.indd 8 12/9/09 4:48:30 PM